scottp3ul

Hello again! I began drawing my exterior walls using even feet (12', 24', ETC...ETC). As I add interior walls my exterior dimensions are changing to odd feet, inches, and fractions of an inch. I know this is due to my own procedural error but how do I keep this from happening? Thanks! Scott

I wasn't holding down the shift key while fencing the ceilings. Thanks for all your assistance!!

I'm able to draw the ceiling plane but I can't seem to get the ceiling plane dialogue box to open. when I fence the area and open the object, I get the room specifications dialogue box

Would it help if I selected the flat ceiling, then build the roof and then change the three vaulted areas to scissor trusses?

Hi Mark, Thank you so much for responding! I was planning on vaulting those three areas with scissor trusses, which is why I selected the no flat ceiling option. I'll check the heel height though and see if it solves it. Scott

https://www.dropbox.com/t/SEPw2ltLQt3UbCX8 Hello! hopefully this link will help solve my problem. Thanks again folks

My mistake.. I tried to zip the file but it's still not small enough

Hoping this works

Hello and thank you for your response. I tried your suggestions and unfortunately was unsuccessful. I also attempted to post my plan to this forum and received a message that the file was too large. Thanks for your assistance! Scott

Hello, I am new to Chief Architect and I am having an issue with the height of four walls. I have tried deleting and rebuilding them but the problem remains. Any help would be greatly appreciated! Scott