AlexAncon

Thanks!  I just went to do that and the intermediate class is full and the advance class isn't there anymore.  I'm pretty aggravated about the way this training is handled.  It took way too long to get a response from them initially, they sent along a survey to determine ability (after my second request) then didn't reply with a suggestion until I have contacted three more times.  Now the class is full and the other option doesn't exist.  Considering how great the tech support guys have been over the years I am really surprised at how badly this has been handled.
 
Needless to say, no training again for now.

Thanks gentlemen!  That told me what I needed.  I appreciate it!

Thank you gentlemen.  Between the two of you-Success.  Got it all corrected.

No luck finding it Joe.  Any idea what topic it may have been under?

Thanks Jerry and Perry!  That was just what I needed!

Thank you!  I will give that a go.  The zero thickness was part of the experiment to get the expansion joints in the stucco to show up in the 3D views (never did get that to work).  Thanks for the tip on layer sets.  Is there also a way to delete the camera views so that the counts on the elevations reset?  For instance I have elevations and sections that are up into the hundreds but I'm actually only going to use about 40 of them.
 
You have noticed that the foundation is totally wrong, but it is being designed by an engineer and I will ultimately delete the one from CA before then plans are submitted for permitting.
 
And thanks for the "turn off all" tip.  That did the trick.  
 
With many thanks!