JamesBolger

Thanks for advice fellas

This may be the first time I've experienced this issue. I found a stone veneer that matches the existing exterior of a house I'm doing some design work for. As you can see from the picture there are several duplicates of the stone I pasted to the wall. Is there a way to cover the entire wall with one instead of multiple? Seems like the material isn't large enough which is ridiculous. Aby suggestions would be helpful.

After I send my floor plan to the layout I have a hard time seeing the plan unless I zoom in and even then the dimensions are barely visible. This happens whether I save as current view or even fit to sheet.

I actually think it would be helpful to know how to adjust for each pane. The upper sash has 6 lites the lower 9

yes the trickier of the two is of course the way I need it done.

cant seem to make a 15 lite double hung window. i can do a 18 or a 16 but no go on the 15 . any suggestions?

Thanks guys, for some reason the program was not recognizing the block wall until I went through the process of exposing the frame wall again. Problem solved . Thanks for your input

I am showing an elevation for a motel with a fir wall tying into an existing block wall and it shows on my 3D perspective but not the elevation. For some reason elevation is showing a separate fir wall connected to the new one. I tried rolling the wall and it’s the same on both sides.. any suggestions