BillyEv

Shayne, I tried that drag roof plan routine. didn't rebuild the roof planes, but rebuiltt he framing. I'm getting an odd truss layout towards the left hand side. when I look inside....hollow like a tim horton's donut.

I can build a truss manually and copy it but i'll be danged if I can get CA to auto draw. Any tips on how to "change the direction" of the trusses appreciated. I even altered the dimensions of my deck to see if that was driving CA choosing joists over trusses.

Hello Any ideas on how I get CA X15 to build scissor trusses? I made them about a couple weeks ago, then went on to tackle some other bugs. Now the trusses are being made like this. I did read the instructions (LINK) and made ceiling planes, as you can see below. But when I direct CA to make framing, I get these joists and not a scissor truss. Thanks in advance for any advice.

I'll post the plan to my google drive, PM me for link. Single story residence 3000 sq ft is created, drawing is to snap, foundation us whole feet where possible, inches where not. Just looking for someone to put the finishing touches on my *.plan and send my plan to a *.layout file with adequate pages and specs to get a building permit approved in SE Michigan. I will start my laundry list of outstanding issues I need to get buttoned up in addition to needing the creation of a *.layout file