• Posts

  • Joined

  • Last visited


-1 Poor

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Can the roof outline be moved from the 1st to the 2nd floor? Thanks, Tom
  2. I certainly appreciate all the help. Tom
  3. Ryan: Thank you for your assistance. When I looked at the solution you provided it made perfect sense to me and I assumed it would fix the issue. However, when I actually got to my office this morning and put it into practice the handles remain as they were, See attached screen shot. the boxes seem to contain the correct information as they were in your reply. I apologize for the solution mix up, not sure what I did. Thanks, Tom
  4. I have a tall cabinet consisting of a pair of high doors, a pair of lower doors with a full width drawer underneath. I have been able to properly locate the door pulls on the upper door, however the pulls on the lower doors default to the center of the door and I have not been able to find a way to move them to elevation that I am desiring. The upper pulls are located 2 3/4" from the bottom of the door and I'd like to have the handles on the lower doors at 2 3/4" from the top of the door. Thanks, Tom
  5. TomSams


    Thank you all for your input. You are correct in that this may be a regional semantics issue. But rgardener has zeroed in on my thinking.
  6. TomSams


    I apologize for being so vague. Let me rephrase my question. Are there any training &/or instructional rsferences on how to build a portico over a garage door with CA?
  7. TomSams


    Are there any references to Porticos over garage doors? Thanks, Tom Sams Premier X13 Cabinetmaker Windows 10
  8. I'm sorry, I started a question concerning stairway width, but figured it out, then ran into this issue and continued on with my question without changing title. However, what you have depicted is what my question was referencing.
  9. Happy Easter / Passover to all of you. I am attempting to draw an L shaped stairway that has a wall on the 2nd set of stairs that runs along the bottom of the stringer and goes to the ceiling. I haven't been able to make this happen, any suggestions? Thanks, Tom
  10. Thank You Mark3D. I think that did the trick.
  11. Thanks Steve, I guess the issue for me is setting the wall to 60", where is that setting?
  12. Good Morning. If I wanted to use a 60" 2nd floor exterior wall height and a 9' ceiling height, what would be the best way to go about it? I realize the wall height is determined by the ceiling height, but I just can't seem to get around that. Thanks, Tom