MosbyBA

I have 19 copies of it running in my office....

Hello again, I was posed an interesting question today and Im not sure how to address their issue. i want to change a default in the cabinet options that is more involved then the defaults you can set with the little wrench defaults. Let me lay the ground work out for you. In Chief, at 24" a base cabinet comes in with a single auto door. At 25" width, that same cabinet will auto double door. The standard cabinets we spec and supply on projects, at 24", is a double door. Now I know I can set the default cabinet type to be a double door cabinet, however any cabinet under 24 ( 18, 15, 12 ) will take the double door, which we do not want. We want it to remain as a single door. Essentially I want to know if there is a way I can change the cut off point for a cabinet to automatically generate the double doors down to 24" or greater, instead of 25" or greater. Advise would be appreciated. Thank you.

HA! Well that was it! I have never seen that before, I scooted the walls down a little away it all went. Thanks for the help, Im coming up on using this software professionally for a year now, so Im still trying to come to grips with some of its quirks, after using Autodesk products for almost 12 years.

Hello Everyone, I will try to keep this as simple as possible. Here is what I see: Notice the connect walls icon is floating next to the cursor, and the circles are on the ends of that wall type, this wall is in our legend. The circles do not display when sent to layout, but they are only there in the plans. The join walls icon follows the cursor around and is very annoying. This is in a newly upgraded version of X6 premier. The wall was built properly, I checked that a few times. Any idea on what might be causing this display?