22trobbins

Really surprised they haven't done this with an upturned camera or section cut.

So I have a question also regarding the labeling of lot lines. is there a way to pull the label off the line, rotate it horizontally and have a leader point to the lot line? in placing my lot plan in layout i've needed to resize the text for viewability, however some of the labels are now overlapping, and I want to clean it up.

So I have a question also regarding the labeling of lot lines. is there a way to pull the label off the line, rotate it horizontally and have a leader point to the lot line? in placing my lot plan in layout i've needed to resize the text for viewability, however some of the labels are now overlapping, and I want to clean it up.

Ah yes, this was the problem - thanks!

Yes, your materials list seems to pick it up. When I run a Materials List for All Floors, this is what I am shown. This is basically the entirety of the materials list.

Yes the wall assemblies have OSB, etc., and the joists are all on the plan. How do I turn on the "layer views" for the materials list?

Just uploaded it!

My material list for lumber is only giving me counts for studs, plates, and headers. I have built framing for the whole house, how come there are no quantities for Floor Joists, T&G OSB, etc...? Thanks! Working on Premier X11 Macy_Residence.plan

I want to calculate all the lumber for my house, but I want to make sure that truss member are not included. How do I know that my materials list excludes this? Thanks!

I want to calculate all the lumber for my house, but I want to make sure that truss member are not included. How do I know that my materials list excludes this? Thanks!

Yes that is a default configuration of how the material list reports. How do I change this default?

Yes.

Yes how can I edit the wall style and what it what materials will report out.

Chief Architect Premier X11 Build: 21.2.0.48x64 When I generate a materials list, I have most of my materials going into the "General GN#" category. I have concrete stem walls, stucco, siding, and many more different materials as a part of the General category. How do I setup the conditions that I am designing to be in specific groups and categories. For example: I want to draw 2x6 exterior wall that will generate quantities that go in multiple categories: - siding quantity - insulation quantity - framing quantity - etc. Thanks