pdiaz4

Members
  • Posts

    21
  • Joined

  • Last visited

Everything posted by pdiaz4

  1. Thank you so much, you're always great help, the one I can't get to do that is the one on the left elevation, it doesn't have a roof under it and the roofs are parallel and the wall is even.
  2. I wasn't able to find it
  3. Because It wasn't connecting properly at the top, there was gaps basically
  4. I unlocked the roof trim and started connecting the frieze board manually but I can't get it to blend at the top.
  5. How can I add trim under board on batten?
  6. Anyone know how to add brick flairs only on top of the garage door?
  7. pdiaz4

    Corbels

    Thank you so much, finally got it!!
  8. pdiaz4

    Corbels

    So the left corbel is correct but still isn't blending in.
  9. pdiaz4

    Corbels

    Here's the plan. Sandcrest SPEC.plan
  10. pdiaz4

    Corbels

    All of them are turned on
  11. pdiaz4

    Corbels

    So I did it exactly how the video was, I tried f12, I tried rebuild walls and it doesn't work. I drew another plan to see if it was me not doing it correctly and it worked, I'm assuming it's because of that second wall kinda creeping out but the walls are the same sizes.
  12. pdiaz4

    Corbels

    How do I shape it in the elevation view? I try creating breaks and it won't allow me to break and manipulate it
  13. pdiaz4

    Corbels

    Thank you! Did you use poly line and make it a solid as well?
  14. pdiaz4

    Corbels

    It is thin like the wall
  15. pdiaz4

    Corbels

    I apologize, a little new at this, as you can tell.. But at this point I'm just trying to figure out if it's even possible for it to blend like the very first picture.
  16. pdiaz4

    Corbels

    I’m sorry I’m just bombing this. I did the point to point and brought it out so it could bump against the siding.
  17. pdiaz4

    Corbels

    Thank you, Now it’s doing this. If I move it to the right, it over laps lines and doesn’t look blended
  18. pdiaz4

    Corbels

    Thank you, Any time I draw the poly line and make it into a solid, it creates only a mold around it and doesn't give me thickness options.
  19. pdiaz4

    Corbels

    Does anyone know how to draw this corbel connected to the boxed eave? I’m using chief architect premier x12