chrismarsho

Picked up the latest set of test plan pages ,Turns out that the advanced line weight setting was the culprit, only issues left are line weights on my elevations ,but hadn't attempted to change those just yet . They seem just a little light for my taste . Imported pics not to bad, don't know if i'm up to tweaking those just yet. Going to keep skulking around this forum looking for relevant post. Thanks again for past advice

Finally found the problem, I think . Early on in the plan and 24x36 layout pages, I was using my 11x17 printer and had set the advanced line weight setting to 1/400 ,in the drawing sheet setup to work with the scale to fit option on my smaller printer ( I was getting huge lines ) . Saved the printer setting and went about my business. I have returned the setting to 1/100 ,I believe that was the original number .Seems to have fixed the problem and layout line weights look good, Will only know after another test page ( have my finger crossed ) . Hope this helps somebody with an obscure printing issue.

Thanks for your advice and will be more accurate with my descriptions

Hello everyone I'm new to this site and x10 , I need some help with line weights on my plan. I'm able to control most of the line weights in the plan with the exception of a kitchen cabinet floor plan on my layout sheet increased to 3/4" = 1'-0" scale with KBNA annotations .I'm wondering where to to control these weights or is the problem due to the increased scale of 3/4" from 1/4" . I'm using a print house and pdf files to transfer the plans . Also ray traced images seam to be lighter than the files I'm sending out .I have tried printing in B+W to solve this issue .Sending another test print to printer today. Not finding much info on the internet with these issues, Any positive advice or resources would be greatly appreciated . Thanks Chris