NARDesignGrp

Ah, separate materials on either side of the door was the piece I was missing. Thank you Rene!

I did some playing with custom sills, I am able to get the 3D to look accurate if the glass wall is set centered on lower wall, but the plan view shows the sill larger than the curb (and I'm not sure how that is derived). I am struggling to get it to look accurate in 3D for a glass wall set to the outer side of the curb (which is what I need), and I am coming across the same plan view issue. It does work decently well to lift the door off the curb, but I don't love that you can see the glass of the wall between the door and the curb (very picky, I know). I will likely continue with this method, but hope there's a better solution that can tick all of my boxes. SHOWER CURB SILLS.calibz SHOWER CURB.plan

I'm not seeing it in stairs either.

I have gone through every room type, no "Maple 5 Plank Natural" to be found.

I am as well. I have gone through many times again and cannot find it.

Thanks everyone for all of the help! I really appreciate it! Still getting the hang of all of the defaults/depth of everything.

Here's my template plan with the materials in question. !PLAN TEMPLATE 2.7.2022.plan

Yes, I went through all defaults including Room Type definitions (several times to be sure). The highlighted materials are still a mystery to me. Any insight into something I may be missing is much appreciated!

I have a follow up question. When going through the "in use" materials list, is there a way to see what exactly that material is being used for? I have gone through all defaults and changed everything to what I would like but there are still some mystery materials that I am not sure where they are being used. Chief X12

That makes sense, so every default material is then considered "in use" by the plan. Thank you for the help!

In any new plan I open up from my custom template there is a fairly long list of materials being "used" but the only object in the template is a north arrow. Why does Chief save these as used materials? Is there a way to delete them? Thanks for any info on this! Using X12.

Thank you everyone for your suggestions!

I just reinstalled my Chief x9 to my larger D drive because my C drive was in danger of filling up. I can open a drawing and do anything but when I try to close it, I get this error message: "Attempting to write the Master List File. Unable to write to the directory "C:\Users\alia\Documents\Chief Architect Premier X9 Data\". The file cannot be saved." I am confused because I installed everything on my D drive so why is it wanting to go to the C drive? And how do I fix it? Thanks!