CooksDesign

Thank you so much MarkMc for the thorough explanation. It's a bit more complicated than what I was looking for. We use one cabinet manufacturer so the codes are pretty consistent with the exception of the "custom cabinets" in which I would probably just replace the labels manually and add a code for that cabinet in the object information field that will cross reference the correct normenclature in the cabinet schedule and note the finished ends, etc in object information comment field. Perhaps I can make a library of those cabinets. I am using CA catalog cabinets as the manufacturer catalog do not change dynamically. At this point it's probably just easier to manually change them vs having them dynamically change. I appreciate all your help but it's above my education level of CA.

Renerrabbbit, when I enter the code you gave me it comes back as B33. Here again, I think I either typed something wrong or am missing something. %automatic_label[0..1].include?("SB") && type[0] == 'B' ? ('BSC' << ((height - countertop_thickness).to_f.to_i.to_s) << width.to__f.to_i.to_s) : automatic_label%

solver I think I am missing something or I have typed something incorrect. %automatic_label 'BSC' << (((height - countertop_thickness).to_f).to_i).to_s << width.to_f.to_i.to_s : automatic_label%

You are amazing. I will figure out how to do the macros. Thank you so much.

I am working in X15 and love the dynamic cabinet labels but I would like to use my cabinet manufacturers nomenclatures instead of the defaults. For example the sink base cabinet by default says SB33 which I would like to it say BSC3334. I can remove SB and insert width BSC33" but I don't want the inch symbols after it. I would like my label to say BSC3334 (even though the height is 34 1/2") so when I run report or schedule my assistant can just enter what is called out on the print.

I might have better luck trying to find a unicorn. This would be more for qualifying or preliminary designs. Canvas offers a service in which you can scan on your phone although it takes about a week to get them back. You can pay an additional 20% for today’s service but it all adds up pretty quickly. I’m just looking for some thing that will scan and measure existing walls put it in the floor plan and import it to chief. I’m not sure of how complicated this would be but apparently nobody is offering it but I am aware of.

Looking for information on what programs/apps Chief users use to field measure and import into chief architect. I currently use Leico bluetooth with either Room Scan and/or Magicplan although I am looking for an all in one measure, layout, and import to chief to save me a lot of steps and wasted time.

We are a well established Kitchen & Bath Design Studio located in Sarasota, Florida. We are looking for an "in-house" designer to use Chief Architect to create floor plans, elevations, etc.