JacArt

Sorry for the delay and thanks for all your answers.  I was so certain I had done a full camera overview but I probably did a Floor overview.

A few months back I created my own camera view set starting with a full overview on which I unchecked roof and ceiling planes, etc...  I always used this same Camera view set and it worked  just fine.  But when I upgraded to X8, I lost it and had to recreate it and I probably made a mistake at that point.

Thanks again!

Jacqueline

I normally used a full overview camera to show a floor that has a staircase going to a lower level, knowing that the floor overview do not show the stairs.  The full overview camera without the ceiling plane, was the only way I could see the stairs.  

However, since a recent version of Chief, I no longer see the staircase even with a full overview camera.

Attachement:  Stairs are on the lower right corner.  We only see a blank area.

Anybody has the same problem?

You are right.  Sorry for that.  Here is the right screen capture.

Thank you Mick.   I guess I'll have to sit with her to see her unit of measure setup.  I'll let you know if I find the solution.

Jacqueline

I've started a plan in Windows and I sent it to my colleague.  I have X6 for Windows and she has X6 for Mac.  

When she opens the plan, the measurements are different.

Attached is a version of my plan and a screen capture of what she sees when she open's my plan in Mac.

Anybody knows why the units are converted that way?

The measurements seems to be meters presented as '-''.

Example

Windows:  19’-8 ½’’   -  Transleted in meters is should read 5.75 meters

Mac:    5'-28 1/4"  

If 39’’ = 1 meter, then .75 x 39"  = 28 1/4’’

Bizarre!

Layout Gym.pdf

Gym 62.plan