JacArt

Sorry for the delay and thanks for all your answers. I was so certain I had done a full camera overview but I probably did a Floor overview. A few months back I created my own camera view set starting with a full overview on which I unchecked roof and ceiling planes, etc... I always used this same Camera view set and it worked just fine. But when I upgraded to X8, I lost it and had to recreate it and I probably made a mistake at that point. Thanks again! Jacqueline

I normally used a full overview camera to show a floor that has a staircase going to a lower level, knowing that the floor overview do not show the stairs. The full overview camera without the ceiling plane, was the only way I could see the stairs. However, since a recent version of Chief, I no longer see the staircase even with a full overview camera. Attachement: Stairs are on the lower right corner. We only see a blank area. Anybody has the same problem?

You are right. Sorry for that. Here is the right screen capture.

Thank you Mick. I guess I'll have to sit with her to see her unit of measure setup. I'll let you know if I find the solution. Jacqueline

I've started a plan in Windows and I sent it to my colleague. I have X6 for Windows and she has X6 for Mac. When she opens the plan, the measurements are different. Attached is a version of my plan and a screen capture of what she sees when she open's my plan in Mac. Anybody knows why the units are converted that way? The measurements seems to be meters presented as '-''. Example Windows: 19’-8 ½’’ - Transleted in meters is should read 5.75 meters Mac: 5'-28 1/4" If 39’’ = 1 meter, then .75 x 39" = 28 1/4’’ Bizarre! Layout Gym.pdf Gym 62.plan