I wasn't sure if this should go into symbols or here. Since you would still have to make some symbols on your own, this is more of a guide than it is symbols.
The attached plan has cabinets with:
Extended stiles. The extension will NOT bump, only the cabinet will (I actually prefer that)
Side extended back -same thing about bump. 2 versions since they both have
Interior that does not match the exterior- done two ways.
Clipped Corner cabinet where the clips will n
Side just use the drop down and match front, if you are going to have to alter anything like the swing, then change to custom face AFTER you match front.
I use molding lines (build, trim, molding line) -NOT 3D-for all cabinet moldings. I have a keyboard for it, also save molding stacks to a warehouse plan for future use. Note that you have to add the thickness of the floor finish to the height. To that end I change the default for kitchens and baths to match the default for the rest of the