Kanomis

Awesome. Thank you so much! I was trying this in the general deck tab, but never thought to do it at the room level. Thank you!

Hi guys! Somehow I seem to have permanently killed my rebuild deck option. I have turned "rebuild deck framing" on, off, back on, restarted the program, yet I can't get my deck floor to come back! I have deleted and redrawn the deck. All to no avail. Any suggestions?? Plan file attached. Thanks!! Chamberlain.zip

Thank you!

Good afternoon, I'm not a fan of the room dimensions being included in the room label, as it looks messy and sometimes does not fit in the room (see screenshot below). I have looked everywhere I can think to look for the option to toggle these off, but to no avail. Anyone know if this is possible in X16? Thank you!!

Yes. Setting the porch side walls to invisible took care of the upper wall issue as well.

I just manually created the roof planes. I prefer automatic when possible, but I suppose done is better than perfect. And I set the side walls of the porch to invisible, which eliminated the back posts as well as the strange wall sections above. Thought I'd update this thread for anyone else who may benefit in the future, even though it's just me in here. Thanks.

Zipped first file incorrectly. But now I see that the zipped folder is too large to attach..

Hello All, I am wanting to place a covered patio on a 2 story home. When I create the patio room I am unable to get the roof to generate, and the second story exterior walls are strangely extending out to meet the porch columns. I would like to create a very low pitch, gabled roof that remains under the second story windows. What am I doing wrong? File attached. Screenshots below. Any thoughts are appreciated. LHI 35.zip

Well, there is something new to me. I didn't know there was such a thing as plan view, assuming the layer sets filled that role. Looking around, I don't see where to select plan views. Would you mind telling me how to switch those? Thank you!

I've been searching and for some reason I can't find that anyone else has asked this question. Probably means that it's obvious and I'm just extra challenged. Anyway, I want to get dimensions that are just in the plot plan dimension layer. When I'm in the plot plan layer set, I don't want all the house dimensions. But when I add dimensions in that set, I get a dialog box asking if I want to display the plan dimensions. What am I missing? Screenshots below. Thanks!!

Thanks everyone.

I just tricked it into working. I had to push the wall of that gabled section out 1/4" and that seemed to disconnect it from the porch walls, releasing it from matching the porch pitch. Now I have the wall that's a random 1/4" deeper. Is there something I mistakenly did wrong? And yes, I realized that my heel height was making the strange section above the porch beams. Is it possible to manipulate only the porch heel setting, instead of lowering the whole house? Thanks!

Oops. Thanks for pointing that out! New zip attached. New Compressed (zipped) Folder.zip

Good afternoon, Concern # 1: I can't seem to figure out why I have a short section of wall above my porch beams. This has not happened in the past when I have created porches with beams. All of my ceiling heights match. When I try changing the porch ceiling height, it blows everything up. Thoughts? Concern #2: After changing some wall dimensions, the gable below has suddenly dropped from the desired 12/12 to something like a 4/12. The setting still show it as 12/12 but its stuck at the lower pitch. Can't seem to figure out why it's refusing to go back to 12/12. Plan file attached. Any thoughts are greatly appreciated, as always! Thank you! New Compressed (zipped) Folder.zip

Ah, I forgot about page 0! Thank you!!!