LotzCC

What determines the bump push distance for a window or door and can the default be adjusted?

I am trying to draw an odd shaped driveway using the polyline driveway tool, but can't get it to snap to the edge of the spline road. The corners will snap, but not the arc. See attached video screen shot and CA plan. Please help. Cepican-Existing 2024-12-05.zip Spline Road and Polyline Driveway-Screen Video.zip

Thanks Michael. That's definitely a good workaround suggestion.

I have one portion of a roof with an overhang/soffit that extends 2 or 3 feet further than other adjacent roof planes, but the soffit does not extend to the house wall. See attached site photo and screen shot of my current model. Please help.

That works. Thanks.

Is there a way to mark Library items as favorites?

I'm using x15. I have contacted support and will follow up here with a note about the result. Thanks

Thanks for trying. I will send the issue to support if needed.

Hi Eric, See attached plan file. My Template 1.0.plan

See attached image of Chief door component with the exterior door hardware not sitting on the face of the door, but sitting slightly under the face of the door. I doo not see a door hardware placement option for this one. Please advise.

Thanks for your response. I have the roof trim layer unlocked but can't get the molding line to edit.

All, Thanks for all the response. I did a few hours of personal training with Chief trainer and asked them to address several issues like this, but most of the solutions were just work arounds, and manual drawing. I hope the developers are listening and working on solutions. My hack for the flat porch ceiling was to increase the thickness of the porch ceiling finish layers and then match the material to the soffit. See attached images.

I have a half hip roof with the gable roof part of the frieze board missing. Settings include frieze on both eave and gable. See attached image and please advise.

I am working on an as built model and am trying to draw the porch roof and ceiling which is flat and at the same level as the soffit. My first try was to set the finished porch ceiling level at the same elevation as the soffit. This has worked in the past, but in this model there is a cantilevered second floor partially over the porch. When I adjust the ceiling height of the porch room, the entire adjacent first floor ceiling moves down to the soffit level. My second try was to create a separate roof plan for the porch and to increase the dimension of the soffit. This almost worked, but the soffit will not extend under the cantilevered second floor. See attached images of the existing home, views of my model with both tried options, and the model file. Please advise. Bargle-Existing 2024-08-02.plan

That's a good work around. Thanks!