BrentJohnJohn

Greetings, This has got me baffled. I am using a Backdrop that I uploaded (see attached Sky Backdrop I downloaded from the Web). However, when I run a Walkthrough, the Backdrop is not even close (see attached PBR Backdrop). I've also attached the settings page.

Greetings, Is it possible to create a 3d Solid out of a PDF. I'm needing to insert custom text into the plan for a Walkthrough.

Sorry. See attached. Verdexium_Test 03_23_25.mp4

Greetings, I created a Walkthrough (see attached) and the video is very jerky. I've spent most of the morning searching the forum for a solution, but could not find anything. Your assistance will be greatly appreciated. Also, the video took over 16 hours. Verdexium 03_23_25.wmv

Thank you so much for your assistance!!! I will look into this.

Greetings. I am designing an office building and the client may want to have a Robotics Center included. Does anyone know of a recourse that I may get 3d Models of Robotic Machines to insert for the 3D Walk-Through?

Greetings, I finally figured out the issue: I had a short wall on a unchecked layer that was causing the problem.

Greetings, I have been trying to figure this out for the past 2 hours and am not having any luck. For some reason, the foundation is not aligning correctly. However, the wall is one continuous wall – red line. Any help will be greatly appreciated.

TeaTime, I changed the wall type and then re-entered the wall type and all works now.

Greetings, I have worked on this for over 3 hours and cannot find a resolution. My issue is the window exterior trim is covered by a Pony Wall exterior stone (36" height off floor). How do I remove the stone as to not cover the trim? Also, I did create a Sill, but as you can see, the stone is protruding through.

HyperTrex, That is what I needed. I changed the Minimum Alcove and it works perfect. Thanks again!!

All, Thank you all for your responses. I have changed the PDF to a PNG for ease of viewing. I'm wanting to create a Hip Roof Line over the Porch area.

Greetings, It has been awhile since my last post. I have reviewed the Forum for more than an hour and not able to find any suggestions to my problem. Per the attached, I am needing to create a "roof" over the front entrance area. I have tried several different ways, and no success. Forney 01_09_23.pdf Forney 01_09_23 Sample.plan

And how do I change it to feet and inches.

Greetings, It is possible to have the sizes in the Door Schedule to be feet and inches. They are currently in inches.