HaikuDog

Thanks all, found the solution and happily moving forward.

3 minutes ago, solver said:

 

 

You might look again.

 

 

I was looking under Index and not search, thanks.

15 hours ago, Alaskan_Son said:

 

This really depends a lot on what you're trying to do.  Can you expand a bit on what you're attempting to accomplish?

One examples is I'm trying to apply a tile pattern to a wall and rather than duplicating the screen shot it stretches the image to the size of the material region.

18 hours ago, solver said:

Did you search Help for aspect?

Yes and it only discusses ray tracing.

How do I maintain the aspect ratio of a screen capture when applying the material to the model?

Thanks for your help, I'll come back to it tomorrow and see if I can come up with a solution.

7 minutes ago, solver said:

In your camera view, switch to the All On layer set, and make sure all layers are set to display. Always the first thing I do when something is not displaying. If it shows, then the problem is related to layer set display settings.

Went to View/Active Layer Display Options, under layer sets selected All Layers ON and the ceiling is still not there in the two bedrooms and upper bath.

8 minutes ago, solver said:

 

Thank you, though I'm not sure how you are seeing the ceilings in those bedrooms and I am still not. 

I go to View/Active Layer Display Options and Ceiling Planes is checked.

Those settings are as you have shown them above. I have attached the file here. I'm new to CA and self taught, forgive my ignorance here. I've gotten the vaulted ceilings to show in the adjacent machinery room but as you can see they don't show in the bedrooms.

Pole Barn.plan

It is on & vaulted ceilings in adjacent rooms are on. Under Tools, Layer settings, Display Options it is also turned on.

example.pdf

It is on & vaulted ceilings in adjacent rooms are on. Under Tools, Layer settings, Display Options it is also turned on.

I have created a vaulted ceiling, I can see from the wall angle that it has vaulted but the ceiling surface isn't showing up. What am I doing wrong here?