Shay_Bulmer

This makes total sense. I will play with the definition and then add the material textures on my cross section for the layout when I get to that point. Thank you again Eric for taking the time to walk me through this. I appreciate it!

Super. Thank you. The Firland Carriage.plan

I think I'm on the right path, though haven't made the destination yet. I've created an ICF lower wall, with an upper pony wall that mimics a taper top ICF block (the outside layer of foam being thinner) with no foam on the inside layer; I've got the inside wall planes lined up the way they should be, but despite the fact that the "Hang 1st Floor Platform inside Foundation Walls is checked" in my defaults, the slab will not extend to the inner surface of the upper pony wall. I have tried deleting the foundation wall all together, and rebuilding walls/floors/ceilings, but to no avail. As you can see in the photo, the slab still will not extend over. I am afraid there is something simple I am missing.

Thank you both for these methods to tackle this. I'll give the pony wall a shot and create the two wall types I need to produce the desired effect. Thank you!

Hi all. Does anyone have a method for eliminating the interior curb that's created when an ICF foundation wall under a garage extends above the slab? When we build an ICF foundation wall under a slab, we cut off and block out the interior face of the ICF to create a curb that is the same width as the 2x6 wall above; is there a way to extend the slab to the interior plane of the wall above, and cap off the foundation wall below?