sunsetguy2

Chopsaw,,,sir,,thanks so very much for your explanation,, much appreciated !!

Thanks much for posting this ..I am sure this is the solution.. I will swallow my pride here and say that after several hours of study and looking I still cannot find this saved view plan control.. IF one of you would be so kind as so point out the path to that .. many thanks.! I have graded up to X 11 FYI. thanks again !

Good Morning..I certainly need to try again here..to explain ..I do appreciate the comments... thanks ... first...this is in x10.......That screenshot I sent sure did not work well .... I ll try to articulate better here.... So from plan view I ll send my floor pan to layout page 2 sending from working layer set .. then to page 3 i ll send my 2nd level floor plan .. to page 4 I ll send foundation plan..,, What happens is that each new plan replaces the one before it ....I e.. on page 2..it will now show both page 1 and 2 as 2nd level plan... when i send page 3.. foundation.. page 1,2 3 all show foundation pan .. Each new page replaces all the previous ones... instead of each page showing each view as it should. In the end i would have 6 similar pages of the last view sent to layout ..erasing all the prior ones.. To counter this I sent as Image..as explained above.. that worked.. meaning each page showed correctly but print was terrible . could not read lettering .. This has been recurring in X10 since I moved from X9..I have not yet moved to x 11.. trying to get this one to print first .... once again thanks for Input....and patience..much appreciated

screenshot.dwg...this is a close in of lettering from sending as image .. on the prints its barely discernible.. As I mentioned above when i send a page to layout each new number page continues so there are 4 pages of the same thing for example.. Sending views as image was an attempt to resolve the issue so i would have consecutive numbered pages as opposed 5 pages of the same thing. This was suggested on this forum by another who had a similar problem I have actually not had this problem in over 10 years of using Chief ..it started for me in v 10. These are construction drawings for a large R V garage I m doing.. I did see several of your posts about not sending to layout.....very interesting and i am researching it . Thanks much .. screenshot.dwg

Hello Using Chief 10.....Having a recurring print problem in layout.. I know its been in here before , and is an old problem for many of you,...but when we get stuck on something we re still stuck till its fixed... I m not able to resolve it.. When sending a view to layout it works fine.... but as each successive page goes the view stays the same on all pages ..instead of changing on page numbers as before in earlier versions I have sent them as "current screen as image" but all the notes are unreadable.. blurred out when its printed (but looks ok in pdf) .. Also saw notes in here to try .png... I have no experience with that.. Also the question is straightforward.. no reason to Post a plan I M O for this.. Many thanks in advance..

got it!!!many thanks again.. in several years of using this have not had that happen.. much appreciated !!

the reset worked great... but now the slide bars for up and down on the drawing are gone..I went ahead and reset the other options ,,still nothing,,,

to Solver.. yes that worked ..i did the reset and a reboot and all is well your help us much appreciated..thank you sir...

Somehow, I m not sure how, I moved an active layer display too far right temporarily...when I moved it back the right side is still off the screen..no up and down slider... Any suggestions to get it in correct position??its the little things like this that drive us nuts.. Thanks much for any help...