Cassidi

I just found a catalogue with the style of awning I need!

I haven't. How would I go about doing this in this application? Would you mind steering me in the right direction? I am very new in this software :/

Hey everyone. I don't know if this was super dumb of me or not, but this is what I did... I created a polyline solid, and made it the thickness I wanted, then copied and pasted every single one and matched them up. I'm slowly learning, but am still a little confused as to the shortcuts. I'm not really sure what you meant by material regions for the relief Johnny

I am creating a commercial front, and am using aluminum awning. Can anyone help me tilt this, so that the front is slightly lower than the back? I then want to add some cantilevers. Any help would be great! Cassie

Thank you everyone for the advice!

Hi everyone, I am a new user and have successfully created a 3 story commercial/residential building. Now I need to design the exterior... With commercial stucco panels and a mix of stone and lap. I can do the lap and stone, but can't figure out how to make customized panels... I can't even get break wall to work properly. Is there anyway that I can create custom panels in orthographic view? See attached pic.

Thank you guys!!!

I can add more, but I want to make the lite 1/3 up the window, not right smack dab in the middle :/

Does anyone know how to adjust the height of a window lite in a Craftsman Style Window? Any help would help! Thanks dudes.