Hi,
I'm using the Home Designer Pro 2014 software and in the process of designing an addition/renovation to a house a pair of walls have a attached themselves to the plan that won't seem to go away. I have an addition that is projecting out over open space below and supported by two columns. Below this addition is a few steps with a retaining wall that allows for a walk-out lower level. The problem I ran into is when I first added the walls for the addition, the program automatically added foundation walls under the wood framed walls. I was able to delete these foundation walls and then added separate foundation walls to act as the retaining walls for the walk-out lower level, with a separate height of about 9 feet. What happened though was that the program then automatically added walls on top of these foundation walls that attached themselves to the main level exterior walls and the roof. I then created a new wall type and labeled it "retaining wall", hoping this would resolve the problem. I deleted the foundation walls and replaced them with the new retaining walls I created. Even though the foundation walls were deleted, the attached walls above them were not. I have tried numerous times and ways to try to get rid of these unwanted walls on the main level, but they won't seem to go away.
Does anyone have an idea of how to resolve this problem? I could start the drawing over, but I have already invested a lot of time into drawing the plan up to this point.
Thanks
