This was the recommended method by a forum member.
Previously, I was creating the arch in another software, importing and positioning.
I'm practicing the advised technique but hit a tiny snag.
In order to create empty space to place columns under the arch heel, I selected the wall
and placed a cut point then pulled the wall section up. This should work but
how do I precisely do the same thing on the left side. My snaps are not snapping.
If there is a better way to r
This was the recommended method by a forum member.
Previously, I was creating the arch in another software, importing and positioning.
I'm practicing the advised technique but hit a tiny snag.
In order to create empty space to place columns under the arch heel, I selected the wall
and placed a cut point then pulled the wall section up. This should work but
how do I precisely do the same thing on the left side. My snaps are not snapping.
If there is a better way to r