Wainscoting affect on walls?
Just starting this plan. First trying to set a refrigerator and it's not appearing but the main reason for me posting this is this wainscoting affect that happens to my walls at times? Is there a way to prevent this from happening? It is often times the brick from outside bleeding into inside. Super annoying as I do a lot of 3D rendering. I've just been using this program for a little over a year so any advice is appreciated.
I agree with Chop and Eric. Those look like wall coverings. You can add wall coverings in rooms, walls, or even in your wall defaults. You will need to look in all those places and remove the wall covering.
Assuming that your refer shows up in your plan view, then it is probably on a layer that is not turned on in your camera view. Either you accidently turned it off or you switched to a layer set that doesn't have it turned on. You can figure out what layer the refer is on by