Stairs with changes in materials/construction

[TSJDesign]

Anyone know a good way to change a single section of stairs from one material/construction method to another without effecting the connected landings/stair sections?  In the screenshot, i have a concrete exterior stair that I want the final upper section to be wood with railing and open below, but cannot figure out how to make this happen.

 

Thanks Todd

[yusuf-333]

At this point you have to make your auto height of the stair off, and you can replace the landing next to the upper stair by a psolid. So you can edit that stair independently.

Hope that helps, but may not be the only solution as others will post their takes on the issue.

[Joe_Carrick]

The easy way is to put the Landing in after setting each section to the style you want.  The Landing will then take on the characteristics of the lower section. I would still use a slab or psolid to extend the landing as appropriate.

[Dermot]

Just hold the shift key down when you select the upper stair section.

 

This will put you into "multi-select" mode.  The stair dialog will then only make changes to the selected sections and not to any of other the connected sections. 

[TSJDesign]

Thanks Yusuf & Joe - that worked.

 

...and then Dermot swoops in with Magic Sneaky Keys - who knew?!  Very Very useful tidbit - thank you! 

[Dennis_Gavin]

Dermot -- NOW you tell us..........