Corner Boards Tight To Sheathing Layer


Capehouse
 Share

Recommended Posts

Hi Folks,

I'm new to X6, been using 9.5 since it came out. Love the program so far. Jumbo learning curve though.

 

A problem I always ran into was the way chief applied the corner boards. It sticks them over the siding instead of tight to the sheathing, the way it is in the real world, or at least how we do it in Mass. I was hoping X6 would rectify this but apparently not or am I missing something? Our usually practice is to pre build the outside corner boards with either 1x6/1x5 or 5/4 stock and then slap them on the sheathed corners and butt the siding, be it claps or cedar shingles up against them. My drawings always looked odd with the corner boards hanging out off the siding. Any ideas/work arounds?

Thanks in advance, Mike

 

X6

i5-4690

GTX760

 

 

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share