Rooms Broken Up Into Pieces

[KnotSquare]

This is very strange, but I noticed that my base building height was 109-1 1/8" and not the 97-1 1/8" specified by my client.

 

When I go to select a room, it is broken up into several pieces as can be seen in this snipping. I have searched, but can not find any like cases.

 

I have included the project file zipped. The one I made the clipping of is from C1 Final.zip. The other compressed file is a backup I made prior to discovering that I had a room height issue and has the intended roof design on it, just 12" too high.

 

Thanks to anyone that can assist.

 

Mark

C1 w Trusses.zip C1 Final.zip

[KnotSquare]

Thank you. I think when I was starting to lay out trusses I miss took the only invisible wall line for a truss. I do wish that Chief would change to the standards of drafting from the days of hand drafting. It is very clear.  __________  .  __________  <-- example of truss was a line dot line so you knew where each started and stopped. Similar with beams

 

__________  ___  __________

 

Can't get AutoCAD to adopt it, but have a quick way to trick that program.

 

Always appreciate your assistance. I was blinded by my own mistake.

 

Mark