Exporting an STL: No roof after slicing with Prusa Slicer

[heredinger]

After exporting an STL (attached Commercial1-1All.zip) from the Orthographic Full Overview & importing this into the Prusa Slicer, the whole model is displayed. However, after slicing, there is no floor or roof.

Any ideas would be helpful.

Thanks in advance.

 

PS, I was able to print just the walls after exporting an STL from the Orthographic Floor Overview...

[Kbird1]

Don't take it personally...  :) but as you may have deducted by now, not many people Export Plans to .STL to 3D Print them....

 

so you'd be better off Calling Support.

 

M.

 

don't forget to do your forum Signature for future Posts..... the Version can be very important.

 

 

[DavidJPotter]

I have found in my experience that .stl files are very poor for use as 3D exports. I commonly use .dae or .3DS.

 

DJP