Larry_Sweeney Posted April 11, 2022 Share Posted April 11, 2022 A while back I read a thread explaining how to make CA show the garage floor extend out under the garage door to the exterior side of the block wall. I can't locate that thread. Can someone "guide " me to it's location. Many thanks. Link to comment Share on other sites More sharing options...
LevisL Posted April 11, 2022 Share Posted April 11, 2022 This is not the original thread, but @robdyck did mention how he does it in this one: Link to comment Share on other sites More sharing options...
Chopsaw Posted April 11, 2022 Share Posted April 11, 2022 This might be the original but was likely discussed at some point prior as well. Link to comment Share on other sites More sharing options...
Larry_Sweeney Posted April 11, 2022 Author Share Posted April 11, 2022 Levis & Chopsaw...................Thanks for getting back to me so quickly. Yes, those were the threads I was looking for. The one problem I find with this solution, unless I'm doing something wrong, is that you get the "almost" correct look for garage doors, but for a walk-in door the exterior casing extends to the bottom of the concrete floor finish. On the garage door I get a thin layer of the jamb across the boot of the garage door on top of the cement. I guess we just "live with it" and hope that someday CA will fix this. Have a great day. Link to comment Share on other sites More sharing options...
Kbird1 Posted April 12, 2022 Share Posted April 12, 2022 If you have to show the Garage Floor sloped to the door for Code like I do, I leave the floor out of the room, and then use a Polyline Solid drawn in Elevation, which I then break through the Doors over the foundation wall. *Not automatic but same method for a Flat floor works fine too. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now