Drawing webbed trusses


ccollin
 Share

Recommended Posts

Hello,

 

I am a newbie to this forum. I would describe myself as an "intermediate" level user of Chief. I am designing an addition to my cottage and am at a loss on how to draw and display my roof and dimensions so that I can submit it for a engineered truss design for the addition. The existing building has metal webbed trusses (see pic). The top chord rests on the top plate of the exterior side of the wall with a "shim" holding the remaining bearing (no birdsmouth). And the bottom chord rests on nothing inside the wall. So far I can't even seem to draw a rafter without a birdsmouth, and alternatively CA does not support the existing type of truss. Any ideas would be appreciated. Red is the existing building, blue addition. Thanks.

IMG_4561 (1).png

Screen Shot 2022-02-08 at 14.00.21.png

Screen Shot 2022-02-08 at 13.59.59.png

Link to comment
Share on other sites

Start with this setting:  So you don't get a birdsmouth.

 

image.thumb.png.e1419dbd0e8da2418d5997665e10482b.png

 

But then you will have quite a bit of manual building and editing to do at an "expert level".

You will not find a setting for the metal webs....  At least in X13 anyway. 

Most likely that will need to be done with a symbol or molding.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share