Rebuilding Foundation without losing current design


K-Lynn
 Share

Recommended Posts

Is there a way to rebuild the foundation without losing the design I have already done? I need to change the stem walls from 10 ft. to 9 ft. If I select the bedroom room spec  the stem wall height is grayed out. The living space stem wall height could be changed in the room spec. 

Link to comment
Share on other sites

Sounds like you have a ceiling hgt issue above that bedroom. You should be able to just select the rooms and change the foundation accordingly. Make sure you are doing from the foundation level, and not an upper level.

Link to comment
Share on other sites

Thanks for the responses. I do have the defaults set but that did not change anything. I have gone room by room and where I can change the stem wall it is working. The bedroom, bath & closet all have remained grayed out for the stem wall. I have looked at it in 3D and cut a few sections and can't find anything wrong with the ceiling. The ceiling height is the same throughout the basement. Oddly, the wall has moved up but the slab is staying down at the bottom of the footing in those rooms.  ???

 

 

Link to comment
Share on other sites

If you have changed structure settings and they are no longer set to Use Default, you can reset them to the current defaults.

 

ct1.png.ace0bc898bed9e6e9dbad7b1ff5a2e68.png

 

 

If nothing is working, then could you attach the plan file?

Link to comment
Share on other sites

Thanks, that is a time saver! I realized I needed to adjust the stem wall ht. in all floor levels in the defaults. (not just foundation) Then I reset the floor and ceiling hts. for all floors and it worked! Thanks for the tips!

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

  • Member Statistics

    32099
    Total Members
    9156
    Most Online
    IowaChris
    Newest Member
    IowaChris
    Joined