ALIGNING FLOOR PLANS


BruceKC
 Share

Recommended Posts

Thanks everyone, but I'm not sure how either of these methods works.  If I do point to point, it says to hit the double center arrows button and then pick the second point, but it picks the center of the cad drawing rather than a specific point.  I'm not even remotely understanding the copy, place and hold idea.  Sorry, new to X12, haven't really used Chief since X1.

 

Link to comment
Share on other sites

1.  Send main floor plan to main floor plan layout page.

 

2.  Copy main floor plan from main floor layout page.

 

3.  Go to Foundation page in layout, place and hold position.  Change to Foundation View.

 

4.  Go to Second floor Layout page and repeat step 3 except change view to Second Floor.

Link to comment
Share on other sites

David,

 

It took me a couple of minutes to figure out what you were saying, but I did figure it out.  This is PERFECT!  Thank you so much!  This was one of the issues that drove me crazy in X1 and I never did figure it out, so thank you again!

 

 

  • Upvote 1
Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share