Custom pony wall alignment ???


xtal_01
 Share

Recommended Posts

Hello,

 

I have a two part question ...

 

1) how can I ... or can I ... have a custom alignment of my main wall above my pony wall?  I have a 2 x 6 wall on top of 4" blocks.  I see under alignment "outer surface, main layer outside, wall center, main layer inside, inner surface" ... but I want a specific distance.  In my case, 7/8" from the outer face of the 2 x 6 stud / sill ... or 1" from the inside of the stud / sill to the inside face of the block  (both the same as the "real" block measurement is 3 5/8").

 

2) is there a way of adding a layer between the upper and lower wall?  I want a custom sill 7/16" wider (5 15/16 pressure treated sill) than the sill that is part of the wall (the wall will be built then stood up and attached to this).

 

Thanks .... Mike

 

 

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share