Undermount sink symbol w/ counter cut-out

[kwhitt]

I am following the steps outlined here to create an undermount sink symbol w/ countertop cut-out:  https://www.chiefarchitect.com/support/article/KB-03021/importing-symbols-with-custom-counter-holes.html

 

After exploding the CAD block to insert my own counter cut-out, I select the rectangular polyline to draw the cut-out and the symbol disappears - not allowing me to complete the edit.  Any ideas on what I might be doing wrong?  The file is attached.  Thanks.

Baker Bathrooms_11-10-19.plan

[Kbird1]

1 hour ago, kwhitt said:

I am following the steps outlined here to create an undermount sink symbol w/ countertop cut-out:  https://www.chiefarchitect.com/support/article/KB-03021/importing-symbols-with-custom-counter-holes.html

 

After exploding the CAD block to insert my own counter cut-out, I select the rectangular polyline to draw the cut-out and the symbol disappears - not allowing me to complete the edit.  Any ideas on what I might be doing wrong?  The file is attached.  Thanks.

Baker Bathrooms_11-10-19.plan

 

 

You have CAD, Default turned OFF in the ALDO  looks like you had tried placing it a few times....

 

[kwhitt]

Thanks Mick.  I knew it had to be something stupid on my end!  Kevin

[Kbird1]

3 minutes ago, kwhitt said:

Thanks Mick.  I knew it had to be something stupid on my end!  Kevin

 

Happens to the best of us   but honestly I don't think Chief should ever place things on Layers that are Off without asking like it does for  example with Framing etc in some cases.

[kwhitt]

You're right!  Now that I think of it, I was never prompted to reveal this layer.