• ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Member Statistics

    27603
    Total Members
    6254
    Most Online
    cwbhunter
    Newest Member
    cwbhunter
    Joined
  • Similar Content

    • By SNestor
      OK...I've been messing around with the "Tray Ceiling" tool in X12.  Cannot for the life of me figure out how to create a "nested" tray ceiling.  In the help file it shows to unique icons...one for a "tray"...and one for a "nested tray".  I cannot find where this "nested" tray menu or icon exists.  
       

       
      Is the nested ceiling shown below in Example B possible with the Nested Tray Ceiling tool?  Thanks!
       

       
    • By srjbb97
      How do I get the siding to show up on in the gable? See attached pictures.. Also, what is the best way to align the eyebrows along the front?
       
      Thanks in advanced..
       
      Chief Architect X9


    • By David-R
      I am trying to draw suspended ceilings for my office area and having a problem with the suspended ceiling not starting a new grid alignment between some offices in 3D view.  I want each office to have it own ceiling grid layout so I don't end up with small edges and misaligned ceiling tile and lights.  It works between some rooms but not others.  Here is what I do...I use "Draw Line" to layout my ceiling pattern, then I place my recessed lights where I want them, I go into "Room Specifications" -> "Materials" -> "Ceiling Finish" and select "Square Ceiling Tile."  After all that, I go to camera view...I then use "Adjust Material Definition" and select the ceiling.  On the "Pattern" tab and the "Texture" tabs I change the "Horizontal Offset" and "Vertical Offset" to match the lights.  In some cases this works fine and other times the Horizontal Offset and the Vertical Offset don't stop and the interior walls and they adjust the ceiling on the other side of the wall (in the next office.)  I can't figure out what I am doing differently that causes it to work properly some times and not others.  Any help will be greatly appreciated. Thank you, David-R
    • By Designer100
      I cannot figure out how to ge small gable roof above Bedroom 4 on study side to fill out correctly, fascia not showing.. Also porte-co-chere on 1st floor roof to be flat with siding on left side on front part.
       
      Any help would be appreciated.
       
      Thanks 


      McafeeRemodelingNewplan.zip
    • By Designer100
      I do not even have client yet. But contractor roughly gave me info. I need the 2nd floor living area to be under roof of this metail bldg. with 16 ft eave ht. I was making 1st floor ceiling under living area at garage 2 area and then garage area 1 open to steel rafters. When I make a bldg. section it is not putting cabinets and room where it is surpose to be. I want it to be like attached elevation. when I make the garage area to ceiling 11' then it changes the whole right side of bldg. eave ht. 
       
      I would apprciate any help.
       
      Thanks,
       
      Newell 

      Starr.Cole Seabrook Metal Bldg.plan