BoiseDesigns Posted August 21, 2019 Share Posted August 21, 2019 I'm sure somebody has seen this before. Were you able to fix it. Is it an adjustment in Chief or the computer. Any help would be appreciated. Its an X1 program. It was just working on a similar system, but I moved it to a new hard rive and it started distorting only in cut view. please watch the video for full effect. Thank you chiefcrash.mp4 Link to comment Share on other sites More sharing options...
Kenoeightspot Posted August 21, 2019 Share Posted August 21, 2019 Your building may be too far away from the "origin" point Link to comment Share on other sites More sharing options...
Ridge_Runner Posted August 21, 2019 Share Posted August 21, 2019 It may be a video card issue. Don't know what hardware you are running on but at least make sure you have current drivers for the video card. Link to comment Share on other sites More sharing options...
robdyck Posted August 21, 2019 Share Posted August 21, 2019 @BoiseDesignsChief's tech support has been very helpful when I've had any display issues. They'll be able to guide you to give them the info they need for the best shot at resolving that issue. Link to comment Share on other sites More sharing options...
DavidJPotter Posted August 22, 2019 Share Posted August 22, 2019 I have chief 7 -21 on my PC's (2) and they all run just fine so I would suspect your PC hardware and your software drivers. The first one I would update would be your video card drivers (update them) and see if that helps. Provided your supporting hardware is good you should have no problems running any version of Chief. DJP Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now