Door Shown As Glass In Elev But Not In Perspective

[4hotshoez]

And is not glass in the model. Why is it showing different?

Chief - PintoElevations.plan

[rlackore]

That cabinet is a regular panel door with a material of Color-Bone. You need a glass panel door with a glass material assigned to it.

[4hotshoez]

I do not want it to be glass. Bone is correct. And that is its assignment. The elevation is wrong.

[dshall]

And is not glass in the model. Why is it showing different?

I have never noticed that before.  Take a look straight on of the corner cabinet,  it now looks good,  but now the other cabinets are showing the shelves.

 

I tried in new  plan and same thing. I can't believe I have never seen this before.

 

If it is any consolation to you,  once you send to layout,  all is well.

[rlackore]

I do not want it to be glass. Bone is correct. And that is its assignment. The elevation is wrong.

 

I misunderstood - I though you wanted glass. Sorry.

[steve_stuart]

I always run into this problem when I use a full inset door. I have to delete or reduce the depths on the shelves if I don't want to see it in elevation. Overlay doors are fine.

[MarkMc]

It's z-fighting, at least that was what I was told back when. Change the angle of the perspective and it shows in different cabinets.

I have all my templates set with shallower depth shelves standard to avoid it. Have actually considered setting them up with none since I rarely put in a base with shelves and never have a need to show them, just apex qty.

[dshall]

.......... reduce the depths on the shelves if I don't want to see it in elevation. ......

That is the best solution,  just go into the cabinet defaults and reduce the default shelf depth by a 1/4" and all will be good.   But again,  it does not show in layout.

[KilgoreTrout]

It's a z-fighting issue.  It seems to be particularly bad with the default door style.  I think the panel is too thin.  I've noticed that I don't see it with some of the other door styles.