Changing 1st floor heights on finished 2 story as built


MacChief
 Share

Recommended Posts

Created an As Built using defaults and only after completion realize the 1st floor is not correct.

It should be several inches lower and my attempts to fix have resulted in error messages, dead ends and confusion.

 

Drawing defaults are: 

1st floor: Relative Rough ceiling 109 1/8, Absolute Floor Above 121 3/4

2nd floor: Relative Rough ceiling 97 1/8 and so finish ceiling is close enough to what I actually have in the house on the 2nd floor.

 

The actual house info: 

Slab foundation, finish floor to finish ceiling is 95.5", 1st level finish floor to 2nd level finish floor 106.5, 1st floor to garage floor is a 5.5" drop.

 

QUESTION: How to change the whole 1st floor to match what I actually have? As mentioned room by room change is not working or not making sense. 

 

When I change the finished ceiling heights to what I have on the 1st floor the "Floor above" is auto calculated too high. 3"+ larger than is actual measured.

 

 

Thanks for any help,

Chris

 

iMac

CA X9

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share