SINK TEMPLATE FULL SIZE

[Capehouse]

Hi Folks,

I am pretty sure this is doable but for the life of me I can't figure out how.

We are trying to do a full size mock up of a vanity/sink/faucet layout and I need to print a Kohler undermount sink template full size.

I've downloaded the DXF, imported it into Chief and when I go to print the best I can do is 1/2 scale, obviously no help.

Suggestions? Thoughts?

My big plotter is out of commission right now so we are going to print to 11x17 and tape it together.

Chief X7, Windows 10

Thanks in advance, Mike

 

[Alaskan_Son]

2 things...

1. When sending to layout, send at a 1 to 1 scale...
2. When printing, print To Scale, NOT using Check Plot at...

[Capehouse]

Thanks Alaska!

I will give it a try.

I was printing direct from file, not from layout.

 

[DRAWZILLA]

By the way, there is a full Kohler lib. you can download from Chiefs website.

[Alaskan_Son]

8 minutes ago, Capehouse said:

Thanks Alaska!

I will give it a try.

I was printing direct from file, not from layout.

 

 

In that case...

 

1.  Make sure to draw some extra lines outside your template area (perhaps an entire border) just to make sure the whole thing is included in the print job.

2.  Under Drawing Sheet Setup change the scale to 1 to 1.

3.  Again...Print To Scale

[Capehouse]

Sending it to layout worked.

Only problem is it all doesn't fit onto 11x17 so I will print an exact 1/4 and literally cut and tape.

Thanks again!

And how are the Palins?