dimensioning weirdness


Clemsongrad
 Share

Recommended Posts

I'm a bit confused about the dimensioning tool in two situations.

 

In a laundry alcove when I use the interior dimension tool I assume it should measure face of drywall to face of drywall. What I get is 7' - 10", but the arrows go right to the stud.

In the alcove I have a washer and dryer and a utility closet.

The dimension arrows show a correct 2'-3" wide for both the washer and dryer, but the arrow stops short of the symbols and also go to the stud. so when I add up each of the three dimensions I get 7'-8". See attached capture. 

laundry alcove.JPG

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share