Don_Straub_Const Posted October 10, 2016 Share Posted October 10, 2016 I have a kitchen design with blind cabinets in the corners. The cabinets are custom built. I an using the wall elevation for the cabinet builder. I can not get the blind part to show. i have taken a 36" cabinet and reduced one door to 12 and created an opening for the remaining 24. The 24" opening does not show. I then tried a 12" cabinet with a 24" cabinet with no doors next to it. Either way the it does not show in the elevation. the alterations show in the floor camera. I second question how I am getting the wall elevations is saving additional versions of the original plan and removing the cabinets that are in the way on adjoining walls. Is there a way to hide the cabinets so I can do all this in one file? attached is a pdf of the east wall elevation sheet. Monterey kit3.plan Monterey kit-Layout east wall.pdf Link to comment Share on other sites More sharing options...
MarkMc Posted October 10, 2016 Share Posted October 10, 2016 Quote Is there a way to hide the cabinets so I can do all this in one file? attached is a pdf of the east wall elevation sheet. Put the cabinets from the second wall on another layer and hide that layer. Link to comment Share on other sites More sharing options...
ShaneK Posted October 10, 2016 Share Posted October 10, 2016 Good luck Link to comment Share on other sites More sharing options...
MarkMc Posted October 10, 2016 Share Posted October 10, 2016 Forgot to mention-make a new layerset to go with that where that layer is off, so that your other views don't get messed up, may want a third layerset for the other wall elevation Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now